Craftsman 113.228360 Owner's Manual page 11

,
,
Place lathe bed near front of workbench in the posi-
tion you want it to be permanently attached. The
front of lathe bed should be positioned a minimum
of 61/2 " from front edge of workbench and the work-
bench must extend past both ends of lathe.
PtJsh the two lathe bed sections tightly together
where they meet. (See illustration.) Using a pencil
or nail mark the center of each of the five holes
onto the workbench surface.
TWO BED SECTIONS PRESSED
TIGHTLY TOGETHER
MARK HOLES AT --
THESE FIVE SPOTS
ILLUSTRATION SHOWS
REAR OF LATHE
i ii i ii i , i
WARNING: Check under the workbench before
drilling holes to make sure electrical wires, gas
pipes, etc., will not be hit by drill bit.
5. Move lathe bed out of the way so pencil marks can
be seen. Using a ddll and 5/16" bit, drill through
work bench at each pencil mark. (Use a center
punch or nai3 to dent workbench surface at each
pencil mark before drilling holes. This will prevent
holes being drilled off center.)
6. From the loose parts bag locate four, black 114"flat
washers. Position one washer over each drilled
hole, except hole drilled at center of bed. Now po-
1t4" HEX HEAD
,
.
sition lathe bed so holes in bed line up with holes
in washers and holes drilled in workbench. (See
illustration.)
From the loose parts bag find four (4) t/4" x 2-1/2
hex head bolts. Place the four bolts through drilled
holes at each end of lathe bed and down through
workbench, (Supplied bolts are for use with a one
inch thick workbench)
From the loose parts bag find four (4) 114" fiat
washers, four (4) 1/4'° Iockwashers, and four (4)
1/4" hex nuts. Position washers and nuts under
table top onto each of the four bolts as illustrated.
(Do not tighten at this time.)
FOUR PLACES
1/4" FLAT BLACK WASHER
11