Mounting And Assembling Headstock - Craftsman 113.228360 Owner's Manual

HANDWHEEL
10/32" SOCKET HEAD SCREW
6, From the loose parts bag locate a 10/32 x 1" socket
head screw, Screw the screw into the back side of
the tailstock as shown, Failure to install this bolt
will allow tailstock to slide off end of bed. Should
it slide off accidentally and fall to the floor, damage
to tailstock and cup center could result.
WARNING: The stop screw is for your protection.
It prevents the talistock from being used part way
off the end of the bed which could cause the tail-
stock to loosen when operated the lathe,
ILLUSTRATION SHOWS
REAR OF LATHE
SOCKET
HEAD
SCREW
TAILSTOCK
LOCK
MOUNTING AND ASSEMBLING
HEADSTOCK
1. Line up V-grooves in headstock with left end of
lathe bed. Slide headstock onto lathe bed as far
as possible,
"_'_"__ E TOC
Ii _ _ yos K
--, lll
Ill I lllll I"U I I,,, Ill II I I, HI I
0
o
€:_-r
0
2. To be sure headstock is positioned properlyon lathe
bed, look under headstock and make sure
headstock housing is touching end of lathe bed.
(See illustration,) Now, place left hand under left
end of headstock assembly, Lift up on headstock
assembly and push it toward bed, Hold headstock
assembly in this position and proceed to step 3.
HEADSTOCK f_
HOUSING
BED END
17