Assembly; Tools Needed For Assembly; Mounting Your Wood Lathe To The Workbench - Craftsman 113.228360 Owner's Manual

assembly
,,. J ,,,,
WARNING:To avoid Injury from unexpected lathe
movement and to provide necessary stability,
mountthe lathe to a stationary work bench with a
top at least i Inch thick.
The lathe should be positioned on workbench approxi-
mately 6-1/2" from front edge of workbench and the
workbench must extend past both ends of lathe.
Tools Needed:
1/8" Hex "E' Wrench
5/32" Hex "U'Wrench
Wrench 7/16"
Socket 7/16"
Ratchet (Socket Wrench)
Socket Extension
#2 Phillips Screwdriver
Drill
5116"Drill Bit
Pliers
Adjustable Wrench
Straight Edge
Hammer
118"HEX%? WRENCH
5f32" HEX "It' WRENCH
7t16"WRENCH
#2 PHILLIPS SCREWDRIVER
PLIERS
ADJ. WRENCH
j ',I ',= 'iF ';i 'i_ ' ,I ',l' ,i ' ,__,p_' Tti _,]
STRAIGHT EDGE
7t16" SOCKET
SOCKET EXTENSION
SOCKET WRENCH
5t16" DRILLBIT
MOUNTING YOUR WOOD LATHE TO
WORKBENCH
,
Locate two sections that make up lathe bed. Place
sections on workbench.Slide thetwo ends against
each other as shown in illustration.
2. Locate center bed mounting bracket in loose parts
bag. Also locate two (2) 1/4-20 x I hex head bolts,
two (2) 1/4" lockwashers and two (2) 1/4" nuts.
Place bolts through holes in center bed mounting
bracket and through holes in center of lathe bed
as shown. Place 1/4" Iockwashers and nuts on the
bolts and hand tighten. To allow alignment of the
bed sections, nuts must be light enough to hold
bed sections in a selected position but not so tight _ A
that bed sections cannot be moved under the bolt / _ _ -_.,_
heads.
/ /
BED MOUNTING
/
J
BRACKET / ,/
' " "=_. 1/4"-20x 1 jr"
10 . ILLUSTRATION
SHOWS'_ HEX
HEAD BOLT-
- . .... ' BACKSIDE OF BED _1