Printing On Roll Paper - Epson Stylus Photo 925 User Manual

Caution:
c
The catcher for 210 mm roll paper can hold only one sheet.
When one sheet is printed, immediately remove the sheet from
the catcher.
To remove the catcher for 210 mm roll paper, pull out the tip
of the catcher being inserted in the printer hole diagonally.

Printing on Roll Paper

Once you have prepared your roll paper and it is loaded in the
printer, you must make settings in the LCD panel in order to print.
Note:
Always check the ink levels before printing on roll paper as replacing
ink cartridges while the roll paper is loaded can smear the paper.
We recommend replacing the roll paper with a new roll when there
is 20 cm remaining. Otherwise, print quality may be compromised
on the remaining portion.
Do not select A4, 100
Size setting when roll paper is loaded in the sheet feeder. Doing so
causes unnecessary paper to be fed after each print job. If you have
already started printing, press the Cancel button. Wait until the
printer stops printing and feeding paper. Cut off the paper at the
back of the printer, then turn off the printer. The remaining paper
is ejected.
Cutting the Remaining Last Photo after
Printing
Follow the directions below to cut the last photo remaining in the
printer when printing is completed.
150 mm, L or 2L sheet paper for the Paper
65