Fujitsu ETERNUS VSS Hardware Provider 2.1 User Manual page 126

Chapter 9 Messages
9.3 Detailed Error Codes
invalid OLU.
invalid BoxID.
invalid Role.
setup is inadequate
communication interrupted.
the session mode was not changed.
the session mode crosses.
the operation of SnapOPC was failed.
the operation of REC buffer was failed.
the operation of concurrent suspend was
failed.
invalid Snap Data volume.
Detailed error code
ETERNUS VSS Hardware Provider 2.1 User's Guide
Copyright 2012 FUJITSU LIMITED
Check the device that is the copy source or the device
partition information of the copy destination, and retry the
function. If this error still occurs, collect material for
troubleshooting, and then contact your Fujitsu system
engineer (SE).(*1)
Check the connection conditions between cabinets, and retry.
If this error occurs again, then contact your Fujitsu customer
engineer (CE).
Check the connection conditions between cabinets, and retry.
If this error occurs again, then contact your Fujitsu customer
engineer (CE).
Take one of the following actions:
•
Checking/Setting the license of the Advanced Copy option
•
Checking/Setting device resources such as "Unset table
size", "Lack of table size", and "Unset REC buffer size".
Check the connection state between the cabinets, and retry
processing. If the error occurs again, contact a Fujitsu
systems engineer (CE).
Check the connection status between cabinets and then retry.
If this error occurs again, call your Fujitsu customer or
systems engineer (CE or SE).
Check the connection status between cabinets and then retry.
If this error occurs again, call your Fujitsu customer or
systems engineer (CE or SE).
Take one of the following actions:
•
Check the partition information for the copy destination
disk, and then rerun the command.
•
Check the status of SnapOPC session, and then try again.
•
SnapOPC is not supported by this device. Try again using
SnapOPC+.
If this error occurs again, call your Fujitsu customer or
systems engineer (CE or SE).
Check the settings status of the REC transfer buffer and then
rerun the command. If this error occurs again, call your Fujitsu
customer or systems engineer (CE or SE).
Check the status of all sessions, and then rerun the
command. If this error reoccurs, call your Fujitsu customer or
systems engineer (CE or SE).
Take one of the following actions:
•
When a copy type is SnapOPC/SnapOPC+, check that
the copy destination is the Snap Data Volume.
•
When a copy type is SnapOPC/SnapOPC+, check that
the copy source is not the Snap Data Volume.
•
When a copy type is a type other than SnapOPC/
SnapOPC+, check that the copy destination and source
are not the Snap Data Volume.
•
For Snap Data Volume initialization, check that the Snap
Data Volume is specified.
If this error occurs again, call your Fujitsu customer or
systems engineer (CE or SE).
126
Action
P3AM-4582-03ENZ0