Preparing The Musiccast Client Remote Control - Yamaha MCX 1000 - MusicCAST - Digital Audio Server Manual

Preparing the MusicCAST client
remote control
■ Inserting the lithium batteries
1 Slide out the battery holder from the remote
control by pushing into the hole in the holder
with a ball-point pen, etc.
2 Place the battery in the holder, positive side
upward.
3 Slide the holder into the remote control.
3
2
1
■ Battery replacement
If you find that the remote control must be used closer
to the main unit than usual, the battery is weak.
Replace the battery with new one.
■ Notes on the lithium battery
Please take care when using the lithium battery as it
may explode if mistreated.
• Never disassemble the battery.
• Be sure the battery polarity is correct. If it is not installed
correctly, it may cause fire or explosion.
• Avoid placing the lithium battery or the remote control
with the battery installed, in high temperature areas such
as in direct sunlight.
• Do not recharge the battery.
• When replacing the battery, make sure to only use a
CR2025 battery.
• Keep the battery out of reach of children. If swallowed,
get immediate medical help.
• When disposing of the battery, insulate it with tape, etc.
Never dispose of it in fire. Also, dispose of the battery
according to local regulations.
• If the battery leaks, dispose of it immediately. Avoid
touching the leaked material or letting it come in contact
with clothing, etc. Skin contact may cause burn. If it
occurs, wash with water promptly and get medical
attention.
■ Using the remote control
Approx. 6m
• If using this remote control causes other equipment to
malfunction, change the location of the equipment.
• Do not spill water or other liquids on the remote control.
• Do not store or leave the remote control in conditions of
high temperature or humidity, such as near a stove, heater,
or bath.
• Do not place the MusicCAST client in locations where the
signal receiver will be in direct sunlight or near lighting
equipment. The remote control may not function correctly
in these conditions.
9
Getting started
Signal receiver