Figure 3.27 Read Defect Data Command (37): Defect Data Configuration - Fujitsu MAX3073NC - SCSI,80, Dell DC961,Hard Drive Scsi Logical Interface Specifications

PList GList
1 1
1 0
0 1
0 0
Defect List Format
0 0 0
1 0 0
1 0 1
The "Transfer byte length" field in the CDB specifies the defect data length (number of bytes) that can
be received by the INIT. The IDD terminates data transfer when transfer of the length of defect data
specified in the "Transfer byte length" field is completed or when transfer of all the defect data of the
specified type is completed. Also, when zero is specified in the "Transfer byte length" field, this
command is terminated without execution of data transfer.
Figure 3.27 shows the format of defect data transferred to the INIT by this command.
Byte
Header
Defect
~
~
Descriptor
List

Figure 3.27 READ DEFECT DATA command (37): Defect data configuration

(1) Header
a. P List (primary list) bit
When this bit is "1," it indicates that P List defect data are included in the defect descriptor list that is
actually transferred to the INIT. When it is "0," it indicates that the P List defect data are not
included. See 3) of item (2).)
C141-C010
P List and G List
P List only
G List only
4-byte header information only (described in this section)
Block Address Format
Byte Distance from the Index Format
Physical Sector Address Format
Bit
7
0
1 0
2
3
4
~
~
n
Defect Data Type
Defect Data Format
6 5 4 3
X'00'
0 0 PList GList
Defect List Length (MSB)
Defect List Length (LSB)
Defect Data
3.3 Format Commands
2 1 0
Defect List Format
~
~
3-95