Roll Assemblies #2 & #3 - Epson EPL-N1600 Option Service Manual

EPSON EPL-N1600 / Duplex Unit
4.2.16 Roll Assemblies #2 & #3
1. Remove the Duplex Unit.
2. Remove the Plate Base.
3. Set the Horizontal Unit on the Support Duplex L/H-.
4. Remove the two screws that are securing the Chute Assembly to
the Support Duplex-R/H.
5. Carefully pull the Chute Assembly a few inches away from the
Support.
6. Remove the E-ring from the end of Roll Assembly #2 (shaft with two
rubber rolls).
7. Remove the bearing from the top end of Roll Assembly #2.
8. Slide the Roll Assembly #2 down to free the bearing at the bottom
end of the Assembly.
9. Pull the top end of the Roll Assembly #2 away from the Horizontal
Unit and remove the Assembly.
10. Remove the E-ring from the end of Roll Assembly #3 (shaft with one
rubber roll).
11. Remove the bearing from the top end of Roll Assembly #3.
12. 1Slide Roll Assembly #3 down to free the bearing at the bottom end
of the Assembly.
13. Pull the top end of the Roll Assembly #3 away from the Horizontal
Unit and remove the Assembly.
Rev. 0
Chapter 4 DISASSEMBLY AND ASSEMBLY
Figure 4-16. Roll Assemblies #2/#3 Removal
40