Chute Lower & Roll Assembly - Epson EPL-N1600 Option Service Manual

EPSON EPL-N1600 / Duplex Unit
4.2.10 Chute Lower & Roll Assembly
1. Remove the Duplex Unit.
2. Remove the Chute Upper.
3. Remove the Duplex Assembly Unit Vertical.
4. Remove the Chute Cover.
5. Remove the two screws that are securing the Chute Invert-V/TRA to
the Frame R/H and Bracket Pivot R/H.
6. Pull the Frame R/H away from the Chute Invert-V/TRA so you can
free the Chute Lower right pivot from the Frame R/H.
7. Slide the Chute Lower to the right and free the Chute Lower left
pivot from the Frame L/H and remove the Chute Lower from the
Frame.
8. Remove the E-rings from both ends of the shaft of the Roll
Assembly.
9. Remove the Bearing from the right end of the shaft:
10. Remove the Gear and Bearing from the left end of the shaft.
11. Lift the Roll Assembly off of the Chute Lower.
Rev. 0
Chapter 4 DISASSEMBLY AND ASSEMBLY
Figure 4-10. Chute Lower/Roll Assembly Removal
34