Panasonic WV-SC384 Operating Instructions Manual page 123

Important:
• After completing the upgrade, delete temporary
internet files. (☞ Page 137)
• Upgrade the firmware using a PC in the same sub-
net as the unit.
• Follow the instructions from the dealer when
upgrading the firmware.
• Application software upgrade
Use the designated file (extension: img) for the firm-
ware upgrade.
The name of the firmware to be used for the
upgrade should be "model name (Use small letters.
"WV" is not required.)_xxxxx.img".
* ("xxxxx" indicates the version of the firmware.)
• Driver software upgrade
Use the designated file (extension: bin) for the firm-
ware upgrade.
The name of the firmware to be used for the
upgrade should be "model name (Use small letters.
"WV" is not required.)_xxxxx.bin".
* ("xxxxx" indicates the version of the firmware.)
• Do not turn off the power of the camera during the
upgrade process.
• Do not perform any operation during upgrading and
wait until it completes.
• The following network settings will not be reset
when upgrading the firmware after selecting "Reset
the settings to the default after completing the
upgrade. (Except the network settings)".
On/Off for DHCP, IP address, subnet mask, default
gateway, HTTP port, HTTPS port, connection proto-
col (HTTP/HTTPS), CRT key, server certificate,
UPnP setting, line speed, bandwidth control (bit
rate), time & date
• The preset position settings will not be reset when
upgrading the firmware after selecting "Reset the
settings to the default after completing the upgrade.
(Except the network settings)".
• The viewer software used on each PC should be
licensed individually. Refer to your dealer for the
software licensing.
123