Connecting Associated Products (Commercially Available) - Kenwood R-K1 Instruction Manual

Connecting Associated Products (Commercially Available)

Digital component 1
Optical Digital Optical Digital
Audio In Audio Out
The earth terminal with
the H symbol is used
for noise reduction of
turntable. It is not for
safety earth.
Signal GND wire
Turntable with MM cartridge
÷ For turntable with equalizer amplifier, connect it to the
[AUX IN] terminal.
÷ Moving coil (MC) cartridge turntable cannot be used di-
rectly from the unit. Use a dedicated equalizer amplifier
and connect this to the [AUX IN] connectors.
÷
Before connecting associated system products, be sure to read their instruction manuals.
÷
Connect every connection cord firmly. Incomplete insertion may cause loss of audio output or generation of noise.
÷
If the speaker cord is connected by inverting the + and – polarity, the reproduced audio will be unnatural with unclear positioning of
musical instruments.
Digital component 2
Coaxial Digital Audio In Coaxial Digital Audio Out
AUDIO OUT
Cassette deck
AUDIO IN AUDIO OUT
AUDIO OUT
VCR, etc.
Notes on the shorting pin on the [PHONO IN] connectors
÷ The system comes with a shorting pin inserted into the
[PHONO IN] connectors. If you want to connect an analog
disk turntable, remove the shorting pin and store it care-
fully so as not to lose it.
÷ Do not connect the removed shorting pin to output con-
nectors.
Connections
MD recorder
AUDIO IN AUDIO OUT
9
EN