Message List - Kenwood R-K1 Instruction Manual

Amplifier Block (continued)
Symptom
The recorded audio is interrupted.
Tuner Block
Symptom
Radio stations cannot be tuned.
Noise interferes with reception.
A preset station cannot be received by
pressing the P.CALL key.
CD Block
Symptom
No audio from the loaded disc.
No sound output.
CD sound skips.
Remote Control Unit
Symptom
Remote control is unavailable.

Message List

Displayed Message
[CD No Text]
[CD PGM mode]
[Check Disc]
[Non-PCM]
[Unlock]
[– – – kHz]
* The CD records information called TOC (Table Of Contents) in addition to music data. Like the table of contents of a book, the TOC
data includes data that cannot be rewritten, such as the number of tracks, their play time and other character information.
÷ Do not adjust the input level (see pages 22 and 32) or switch the Source Direct func-
tion ON or OFF (see page 16) in the middle of recording on an external component.
÷ Connect the antennas properly as described in "Connecting the antennas". (See
page 6.)
÷ Select the appropriate radio band as described in "Receiving radio broadcast-
ing". (See page 23.)
÷ Tune the frequency of the desired radio station as described in "Receiving radio
broadcasting". (See page 23.)
÷ Install the outdoor antenna away from the road.
÷ Switch off the nearby electrical appliances.
÷ Install the system away from a TV or PC.
÷ The frequency of the preset system cannot be received with the system.
÷ Select the [TUNER] input.
÷ Place the CD properly with the label side up. (See page 17.)
÷ Clean the disc as described in "Care and storage of CD". (See page 37.)
÷ Wait for the condensed dew to evaporate as described in "Care and storage of
main unit". (See page 37.)
÷ Press the CD 6 key to enter play mode.
÷ Clean the disc as described in "Care and storage of CD. (See page 37.)
÷ Install the system in a vibration-free environment.
÷ Clean the disc as described in "Care and storage of CD". (See page 37.)
÷ Replace the batteries with new R03 batteries. (See page 12.)
÷ Point the remote control unit to the remote sensor of the system and control it
from within the controllable distance. (See page 12.)
÷ The CD does not contain the CD-TEXT information.
÷ Random playback is attempted in the program play mode.
÷ The TOC data* of the CD cannot be read.
÷ The disc is not loaded properly.
÷ A signal other than a PCM signal is applied to the [DIGITAL (OPTICAL) IN 1] or
[DIGITAL (COAXIAL) IN 2] connector on the rear panel.
÷ The component connected to the [DIGITAL (OPTICAL) IN 1] or [DIGITAL (COAXIAL) IN 2]
connector on the rear panel is not switched ON or no signal is input from the com-
ponent.
÷ The sampling signal used with the PCM signal being input is not compatible with
this system.
Troubleshooting
Remedy
Remedy
Remedy
Remedy
Description
39
EN