Samsung GN642FFXD Installation And User Manual page 16

Cleaning and Maintenance (Continued)
BURNERS
■ Remove the burner lids and Flame Spreaders by pulling them upwards and away
from the top plate.
■ Soak them in hot water and a little detergent.
■ After cleaning and washing them, wipe and dry them carefully. Make sure that the
flame holes are clean and completely dry.
■ Wipe the fixed parts of the burner cup with a damp cloth and dry afterwards.
■ Gently wipe the Ignition device and flame supervision device with a well wrung-out
cloth and wipe dry with a clean cloth.
■ Before placing the burners back on the top plate, make sure that the injector is not
blocked.
■ Re-assemble the Auxiliary, Semi-Rapid and Rapid burners
as follows :
14
15
16
Replace parts in the correct order after cleaning.
- Do not mix up the top and bottom.
- The locating lugs must fit exactly into the notches.
1. Place the flame spreader (15) on to the burner cup (16) so that
the ignition device and the flame supervision device extend
through their respective holes in the flame spreader.
The flame spreader must click into place correctly.
2. Replace the burner lid (14) ensuring that the locating tabs fit
into the noches in the flame spreader (15).
15