Software For Ms-Dos; Commands For Running Silentwriter Dos Software; The Print Navigator - NEC 1760 - SilentWriter B/W Laser Printer User Manual

Software for MS-DOS

This section describes the Silentwriter software for
MS-DOS. If you used the express installation method
for DOS, the following software was loaded onto your
system
• Print Navigator software
• DOS Print Monitor software
During express installation, the Silentwriter is set as the
default printer on LPT1. The printer must be connected
directly to the computer to run the Print Navigator
software. Complete software installation instructions
are provided in Chapter 3 of the Easy Printer Setup
Guide.
Commands for Running Silentwriter
DOS Software
To launch the Print Navigator application, type PANEL
at the DOS prompt. This displays the Print Navigator
screen shown below.
To load DOS Print Monitor software, type MONITOR at
the DOS prompt.
To unload DOS Print Monitor software, type NOMONITR
at the DOS prompt.
To display the DOS Print Monitor, press the Hot Key
combination (the default is Ctrl+Alt+S).
2–8 User's Guide

The Print Navigator

You can use the Print Navigator in place of the printer's
operator panel to change printer settings. It consists of
five screens that allow you to update your printer
settings, also called printer profiles, from your
computer. You can also view your printer's current
profile on your monitor. And you can save current
profile settings for use at a later time.
In addition to the standard printer settings, the Print
Navigator provides the following PCL Job settings:
Lines per page, Typeface, Points and Pitch, and Symbol
Sets. These are defined in Chapter 1.
To launch the Print Navigator application, type PANEL
at the DOS prompt. This displays the Print Navigator
screen shown below.
Page Screen in the Print Navigator