Loading Documents In The Adf; Preparation; Introduction; Scanner - Fujitsu 6240 - fi - Document Scanner Operator's Manual

Chapter 2 How to Load Documents

2.1 Loading Documents in the ADF

This section explains how to load documents in the ADF.

Preparation

For details about the paper size and quality required for normal
operations, refer to "2.3 Documents for Scanning (ADF)" (page
41).
1
If you are loading multiple sheets, check the documents.
1 Check if the documents to be loaded are of the same width or
different widths.
Ways to load documents differ depending on whether they are the
same width or not.
If the document width varies, refer to
Scanning" (page 47) or "Documents with Different Widths" (page
69).
2 Check the number of sheets.
Up to 50 sheets can be loaded (with paper weight of 80 g/m² [20 lb]
and thickness of the document stack under 5 mm).
For details, refer to "Loading Capacity" (page
2
"Conditions for Mixed Batch
44).
Fan the documents.
1 Grab a stack of documents, which should be 5 mm or less.
2 Hold both ends of the documents and fan them a few times.
3 Rotate the documents by 90 degrees and fan them in the same
manner.
4 Perform steps 1 to 3 for all documents.
5 Align the edges of the documents.
For more details about how to fan documents, refer to the
Error Recovery Guide.
The Error Recovery Guide is included in the Setup DVD-
ROM. For details about installation, refer to "Installing the
Software" in Getting Started.
TOP
Contents
Index

Introduction

Scanner

Overview

How to Load

Documents

Configuring the

Scan Settings

How to Use the

Operator Panel

Various Ways to

Scan
Daily Care
Replacing the
Consumables
Troubleshooting
Operational
Settings
Appendix
Glossary
38