HP 157770-001 - DAT Drive 20/40 Tape Configuration Manual page 16

For example, when an HP DAT160 drive is found, it will be displayed as something like:
Hardware Path
===========================================================
8/0/2/0.3.0
3. Highlight the drive and select the following from the tool bar:
Actions
Create Device Files
Create Default Device Files
This will create default device files for the drive. To view the device files that have been created,
select:
Actions
Create Device Files
Show Device Files
4. When you have exited
%/sbin/ioscan –fnC tape
All default device files displayed have compression enabled.
NOTE: HP recommends the 'Berkeley' device files for most applications:
cXtYdZBESTnb
cXtYdZBESTb
where:
= card number
X
= target number (drive SCSI ID)
Y
= LUN number
Z
For HP-UX 1 1i v3 (HP-UX 1 1.31)
1. Start up the SMH web-based interface:
%
smh –w
This will attempt to launch a web browser. Mozilla browser
installed.
2. From the SMH Tools page (see
Peripheral Devices section.
1. If Mozilla is being invoked for the first time you may be asked to agree to license terms for the software.
16 HP (HP-UX) servers and workstations
Driver Description
stape HP DAT160
, run to see the tape drive:
sam ioscan
= Berkeley, no rewind, best available density
= Berkeley, with rewind, best available density
Figure 3 on page 14), select Manage Peripheral Devices from the
1
is the default when HP-UX 1 1i v3 is