HP 157770-001 - DAT Drive 20/40 Tape Configuration Manual page 13

Kernel Configuration
Drivers
3. Highlight the
stape
Pending State will read "Out".
4. Select the following:
Actions
Add Driver to Kernel
The Pending State will now read "In".
5. To add the new driver to the kernel, select:
Actions
Create a New Kernel
The or
stape schgr
6. If you are going to attach an autoloader, use a similar procedure to change
7. Reboot the system.
For HP-UX 1 1i v2 (HP-UX 1 1.23)
1. Enter at the command line.
sam
%
sam
2. Select the following:
Kernel Configuration
Kernel Configuration (character mode)
Modules
3. Highlight the
stape
Planned State will read "unused".
4. Type " " to modify the stape driver and "
m
"static".
5. If you are going to attach an autoloader, use a similar procedure to change
6. The and
stape schgr
7. Reboot the system.
For HP-UX 1 1i v3 (HP-UX 1 1.31)
1. Start up the SMH web-based interface.
% smh –w
This will attempt to launch a web browser. Mozilla browser
installed.
1. If Mozilla is being invoked for the first time you may be asked to agree to license terms for the software.
HP Evolution II DDS/DAT drives: UNIX, Linux and OpenVMS configuration guide
driver. If the driver has not been added to the kernel, both Current State and
driver is added to the kernel.
driver. If the driver has not been added to the kernel, both Current State and
s
drivers are now added to the kernel.
" to set it to "static". The Planned State will now read
1
is the default when HP-UX 1 1i v3 is
to "static".
schgr
to "static".
schgr
13