Nokia 002F581 User Manual page 62

4. After defining the settings, select
Advanced settings
Back to save the settings and exit.
Advanced internet access
point settings for packet data
(GPRS)
Select Menu Tools
>
Access points.
After setting up a basic internet access point for packet
data (GPRS), select
define the following advanced settings:
Network type
•
protocol type. The internet protocol defines how data
is transferred to and from your device.
Phone IP address
•
device. Select Automatic
the device IP address. This setting is shown only if you
select Network type
DNS address — Select
•
Secondary DNS address
if required by your service provider. Otherwise, the
name server addresses are provided automatically.
Proxy server address
•
server. Proxy servers are intermediate servers used by
some service providers between a browsing service and
its users. These servers may provide additional security
and speed up access to the service.
62
Options
to define the advanced settings or
Settings Connection
> >
Options Advanced settings, and
>
— Select IPv4 or IPv6 as the internet
— Enter the IP address of your
to have the network provide
> IPv4.
Primary DNS address
and enter their IP addresses,
— Enter the address of the proxy
Set up an access point for
>
WLAN manually
1. Select Menu
Access
2. Select Options
access point, or select an existing access point from the
list and then
the access point as a basis for the new one.
>
3. Define the following settings.
Connection name
•
the connection.
Data bearer
•
WLAN network name
•
identifier (SSID), that is, the name that identifies the
specific WLAN, select
network from the WLANs in range, select
networks.
Network status
•
you are connecting to is hidden or
hidden.
and
WLAN network mode
•
Infrastructure, devices can communicate with
each other and with wired LAN devices through a
WLAN access point. If you select Ad-hoc, devices can
send and receive data directly with each other, and
no WLAN access point is needed.
WLAN security mode
•
security mode that is used in the WLAN access point.
If you select WEP (wired equivalent privacy), 802.1x,
or WPA/WPA2 (Wi-Fi protected access), you must
also configure the relevant additional settings.
Tools Settings
> >
points.
New access point
>
Options Duplicate access point
>
— Enter a descriptive name for
— Select Wireless
— To enter the service set
Enter manually. To select the
— Select Hidden
— If you select
— You must select the same
Connection
> >
to create a new
to use
LAN.
Search for
if the network
Public if it is not