Yamaha 01V96i Reference Manual page 60

60
Grouping Channels & Linking Parameters
• Out Mute page
This page enables you to set Mute groups (U–X) for Bus
Outs (1–8), Aux Outs (1–8) and Stereo Out.
In Mute page
2.
Press the up ( ) or down ( ) button to select
a group.
3.
Press the [SEL] button for a channel you wish
to add to the group.
The selected channel is marked with "
nel is added to the group.
Example: Input Channels 1–4, 7, 8, and 15, 16 have
been added to Fader group C.
Tip:
• If you add one channel from a pair to a group, the pair
partner is automatically added to the group.
• You can also select a channel on another layer by switching
layers.
4.
In the same way, press the [SEL] button for
other channels you wish to add to the group.
The relative level of the faders for the grouped channels is
determined by the position of the faders when the chan-
nels were added to the group.
The On/Off status of the grouped channels is determined
by the [ON] button status when the channels were added
to the group.
01V96i—Reference Manual
5.
To turn a group on or off, move the corre-
sponding button in the ENABLE column, then
press [ENTER].
When the group Enable button is turned off, the corre-
sponding group is temporarily cancelled.
6.
To use a fader group, operate one of the fad-
ers or level controls for the grouped channels.
7.
To use a mute group, press one of the [ON]
buttons for the grouped channels.
All channels in the group switch their on/off status.
" and the chan-
Note:
• If you wish to change the relative level balance between the
grouped channels while this page is displayed, first turn off
the Enable button or remove the channels for which you
want to change the level from the group.
• If other pages are displayed, press and hold down the [SEL]
button for the desired channels to temporarily remove
them from the group, then change the level balance.
Note:
• While a mute group is enabled, you cannot turn a subset
of the grouped channels on or off.
• If you wish to turn a subset of the grouped channels on or
off, first turn off the Enable button, or remove the channels
you wish to turn on or off from the group.