Installing Drivers - NEC VERSA DOCK Service Manual

Installing Drivers

The drivers for the NEC Versa Dock can be found on the NEC Versa Dock
Software Setup CD. Refer to the
installation for the NEC Versa Dock.
The Software Setup CD dialog box consists of the following components.
n
Selection Tabs — Located just below the title bar, each tab represents a
software category.
n
Description — Located in the bottom portion of the dialog box, the text
describes the selected or highlighted software category or driver.
n
Install — Clicking the Install button installs the selected software.
n
Exit — Clicking the Exit button closes the NEC Versa Dock Software
Setup CD dialog box.
Once the NEC Versa Dock Software Setup CD dialog box appears, follow these
steps to install the desired software.
1. Insert the NEC Versa Dock Software Setup CD into the CD-ROM reader.
If you have a combination of two CD-ROM devices installed
in the NEC Versa and the NEC Versa Dock, be sure you
have the NEC Versa Dock Software Setup CD in the CD-
ROM drive that was installed first and has the lowest
assigned drive letter (such as D:\ or E:\).
2. From the Start menu, type
2. Click the Browse button to access the Setup.exe file on the CD.
4. Click the selection tab of your choice.
4. Click the plus (+) box beside the desired utility to expand the selection.
4. Click the Installation selection to activate the Install button.
4. Click the Install button to install your selection.
4. Click Exit to close the NEC Versa Dock Software Setup CD dialog box.
Follow the on-screen instructions to install your selection.
9. Remove the CD from the CD-ROM reader when the installation is complete.
2-4 System Configuration and Setup
readme.txt file on the CD for details on driver
.
Run