5. Remove the front panel from the NEC Versa Dock by removing the two
screws at the bottom and freeing the four tabs from the top of the panel. Put
the screws in a safe place for use when replacing the front panel.
A - Front panel tabs (4) B - Front panel screws (2)
6. Slide the rear part of the docking tray towards the front of the NEC Versa
Dock until it stops.
7. Remove the cable cover by locating and removing the two top screws. Put
the screws in a safe place for use when replacing the cable cover.
A - Cable cover screws (2)
2-24 System Configuration and Setup
Removing the front panel
Locating the cable cover screws