NEC VERSA DOCK Service Manual page 60

3. Attach the 15-pin cable connector to the monitor port on the NEC Versa
Dock.
4. Secure the cable connection with the screws provided on the cable.
5. Connect the monitor power cable and plug it into a properly grounded wall
outlet.
6. Follow any setup instructions in the monitor's user's guide.
7. Power on the monitor.
8. Power on the NEC Versa.
Press Fn-F3 to toggle between the LCD, CRT, simultaneous CRT/LCD display,
and TV Out (on systems that support TV Out).
Parallel Devices
To install a parallel device such as a printer, you need a cable with a male 25-
pin connector for the system and, for most parallel printers, a Centronics®-
compatible 36-pin connector.
When you connect a printer, be sure to install the
appropriate printer driver through the Windows Control
Panel.
Connect a parallel device to the NEC Versa Dock as follows.
1. Check that both NEC Versa and the parallel device power are off.
2-44 System Configuration and Setup
Connecting a monitor cable