User Programmable Features - NEC DSX Software Manual

Programming and Dialing System Speed Dial
Enter the line number you want the system to use when dialing your stored number (1-64).
a.
b. Enter the Line Group number you want the system to use when dialing your stored number (90-98).
Press
c. INTERCOM
Press HOLD .
6.
Enter the number you want to store (up to 32 digits long).
7.
• If storing Intercom codes, you can enter a valid dial sequence using the digits 0-9, #, and *.
• To insert a pause, press
• Do not enter a pause or flash into an Intercom code.
8. Press HOLD twice.
Enter a name for the Speed Dial number.
9.
• See Name Programming Chart (page 322) for more.
10. Press HOLD .
Do one of the following.
11.
a. Repeat from step 3 to program another bin.
b. Press SPEAKER
To dial a stored System Speed Dial number:
Do one of the following.
1.
Press INTERCOM,
a.
c. Press a Feature Key set up as a System Speed Dial key.
• To chain bins, wait for the first bin to dial out, then press a bin key or Feature Key.
2.
(Optional)
• If the programmed route is busy, press an idle line key to reroute the call.

User Programmable Features

Feature
Speed Dial
DSX Software Manual
if you want to enter Intercom codes.
. To insert a Flash, press
MUTE
to exit.
dial # , then dial the System Speed Dial bin number (normally 201-299).
Programming Personal Speed Dial
Mnemonic
#SP (#77) #SP + Press bin key (for bins 701-710) +
outside line (e.g., 1), Line Group (90-98), or
for Intercom feature +
twice + Name +
to exit.
SPEAKER
.
FLASH
Operation
HOLD
HOLD + Number to store +
HOLD + Press another bin key or
Speed Dial
In these instructions:
[Super Display Soft Key]
[Keyset Soft Key]
Access Level
+ Enter 1-5
INTERCOM
HOLD
Features ◆ 321