Table of Contents
Advertisement
5-8
Disassembly and Reassembly
Standard 3 1/2-Inch Hard Disk Drive Removal
Remove the standard 3 1/2-inch hard disk drive as follows.
1.
Remove the system access cover and front panel as previously described.
Unplug the hard disk drive power and signal cables from the optional hard disk
2.
drive.
Locate the two screws securing the 3 1/2-inch hard disk drive in the molded
3.
plastic cage at the front of the system. Remove the screws.
4.
Release the two plastic clips inside the plastic cage holding the drive in the plastic
cage and slide the drive up and out of the cage.
Fan Assembly Removal
Remove the fan assembly per the following steps.
Remove the system access cover per Section 3.
1.
2.
At the rear of the system unit, press in on the two locking tabs securing the
assembly to the chassis.
3.
Remove the fan by pulling it outward away from the system board.
Figure 5-8 Removing the Drive
Advertisement
Table of Contents
Troubleshooting
