Materials; Customer Supplied Materials; Instructions - ABB TOTALFLOW PGC1000 User Manual

2.16.1 Materials










2.16.2 Customer Supplied Materials



2.16.3 Instructions

1) Gain access to the rear termination board by loosening the countersunk hex
2) Remove the hub plug from the bottom most access hub.
3) Beginning with the internal connection assembly (see Figure 2-28), feed
2103406 Rev. AE
If installing the PGC1000 inside an ENC82, use this
procedure to install the optional RS-232/RS-485/RS-422
outlet box, if required; otherwise, continue to the next series
of applicable instructions. Before beginning, review the
procedure and the materials required for installation.
These instructions are only applicable to the large
environmental enclosure. This option is NOT available for
the small enclosure.
One (1) each - Outlet box assembly
One (1) each - Internal PGC1000 connection assembly
One (1) each - Flexible cable assembly
One (1) each - DC power switch box
One (1) each - Support bracket
Two (2) each - 10-32 x ¾" SS pan head screw, Phillips
Two (2) each - #10 SST flat washer
Two (2) each - #20 SST split washer
14 AWG wire-materials for external wiring (to outlet box) not provided by ABB
Totalflow. The quantity is to be determined by the technician based on
installation and local codes.
socket locking set screw in the rear end cap. Use a 1/16" hex wrench. Upon
completion, unscrew the end cap.
the 13" wire bundle (elbow end of the assembly) through the open hub.
Continue to pull the wire past the terminations until the nipple fitting is in
position to screw into the hub.
Page 2–29