Using The Oscillator - Yamaha 01V96i Owner's Manual

Using the Oscillator

The 01V96i features an Oscillator you can use for
sound checks. Follow the steps below to use the Oscil-
lator:
1.
Press the DISPLAY ACCESS [UTILITY] but-
ton repeatedly until the Utility | Oscillator
page appears.
1
2
This page contains the following parameters:
1
OSCILLATOR ON
This parameter button turns the Oscillator on or
off.
2
WAVEFORM
These parameter buttons select the Oscillator wave-
forms.
3
LEVEL section
The parameter control in this section sets the Oscil-
lator output level.
4
ASSIGN section
The buttons in this section select the Oscillator out-
put.
2.
Move the cursor to the button for the
Oscillator output channel in the ASSIGN
section, then press [ENTER] (you can
select multiple channels).
3.
Move the cursor to one of the WAVE-
FORM parameter buttons, then press
[ENTER].
You can select the following waveforms:
• SINE 100Hz ........100 Hz sinewave
• SINE 1kHz...........1 kHz sinewave
• SINE 10kHz ........10 kHz sinewave
• PINK NOISE ......Pink noise
• BURST NOISE ...Burst noise (200 msec pink noise
pulses at four second intervals)
4.
3
5.
6.
4
Using the Oscillator
Move the cursor to the parameter con-
trol in the LEVEL section, then rotate the
Parameter wheel to set the Oscillator
level to minimum.
Note: Sinewave and pink noise create unusually high
sound pressure. Oscillator levels that are too high can
damage the speakers. When you use the Oscillator, be
sure to set the level to minimum, then raise the level
gradually.
Move the cursor to the OSCILLATOR
ON/OFF button, then press the [ENTER]
or [INC]/[DEC] buttons to turn on the
Oscillator.
The Oscillator signal is now routed to the channels
selected in the ASSIGN section.
Move the cursor to the parameter con-
trol in the LEVEL section, then rotate the
Parameter wheel to raise the Oscillator
level.
You can view the current Oscillator level on the
LEVEL meter.
01V96i—Owner's Manual
45