Installing An Optional Card - Yamaha 01V96i Owner's Manual

18
Control Surface & Rear Panel
SLOT Section
1
1
SLOT
Optional mini-YGDAI (Yamaha General Digital
Audio Interface) I/O cards can be installed in this
slot. You can install AD/DA cards or digital I/O
cards supporting a variety of digital formats includ-
ing AES/EBU, ADAT, and Tascam.
Input signals from an I/O card can be patched to
any desired input channel or insert-in (see page 29).
The output signal of any desired bus or the direct
signal of an input channel can be patched to an out-
put of an I/O card (see page 30).
Note:
• See page 63 for information on the
mini-YGDAI I/O cards that can be currently
used.
• For the latest information about I/O cards,
refer to the Yamaha Pro Audio website.
http://www.yamahaproaudio.com/
Power Section
1
POWER ON/OFF
switch
This switch turns the
power to the 01V96i on
or off.
Note: To prevent loud clicks and thumps in your speak-
ers, turn on your audio equipment in the following
order (reverse this order when turning the equipment
off)—sound sources, multitrack and master recorders,
01V96i, monitoring power amplifiers.
2
AC IN connector
This connector enables you to connect the 01V96i
to an AC outlet via the supplied power cord. Be sure
to plug the AC power cord into this connector
before plugging the power cord into an AC outlet.
Caution
Even when the POWER ON/OFF switch is in the
off position, a small amount of electricity is still
flowing to the unit. When you are not using the
01V96i for a long time, make sure to unplug the
AC power cord from the AC outlet.
01V96i—Owner's Manual
Installing an Optional
Card
Visit the following Yamaha Pro Audio web site to
ensure that the card you are installing is supported by
the 01V96i.
http://www.yamahaproaudio.com/
Follow the steps below to install an optional
mini-YGDAI card.
1.
2.
3.
1 2
4.
Make sure that the power to the 01V96i
is turned off.
Undo the two fixing screws and remove
the slot cover, as shown below.
Keep the cover and fixing screws in a safe place for
future use.
Insert the card between the guide rails
and slide it all the way into the slot, as
shown below.
You may have to push firmly to fully insert the card
into the internal connector.
Secure the card using the attached
thumbscrews.
Tighten the screws firmly to secure the card. Other-
wise, the card may not be grounded correctly.