On/Off Button; Setting The Language - Electrolux 6 Series Service Manual

4.4.2 On/Off button

The On/Off button is the only one in the series 9 styling that is not a touchkey.
When turning on for the first time or after quitting the diagnostics system the machine will request you to set
the language in which programmes are shown on the display and to adjust the time shown on the display.
Press this button to turn on the appliance; the first position at the top right is selected by default (except in
special circumstances, for instance, if there is a power failure), the display shows the type of programme
selected and for a few seconds the current time, so that the user can check that the time setting is correct,
after which the end of cycle time is displayed.
The end of cycle time shown on the display should not be considered as a set time, since it is calculated
according to a normal load with a given humidity, and obviously if the appliance load is lighter or the degree
of humidity of the fabrics in the appliance is different, the time will change automatically and gradually as
drying progresses.

4.4.3 Setting the language

When turning on for the first time or after quitting the diagnostics system the language must be set.
The text line shows the set language, after 3 seconds if no other button is pressed a help message is
displayed inviting the customer to turn the dial and select the language, after a further 3 seconds a second
help message is displayed, inviting the customer to press the Start/Pause button to confirm the language
selected.
These messages are in the default language indicated in the configuration file, and corresponding to the
language indicated in the printed label on the panel.
When the dial is turned, the language changes at every step and, after the timeout (3 seconds), the help
messages are displayed in the new language that has been selected.
When the Start/Pause button is pressed the selected language is confirmed and the display switches to the
next step, which is adjustment of the clock.
If a language is selected by mistake by pressing Start/Pause or if you wish to change language, go to the
paragraph key combinations – change language.
If the language displayed on first switching the machine on is the right one there is no need to turn the dial,
simply press Start/Pause.
Technical Support - A.D.L. 48/76 599 74 12-74 Rev.01