Loosen the 2 screws that hold the inverter
motor board support rod.
Pull it upwards and remove it.
Disconnect the motor connector.
Using a pair of pliers, detach the spring that
keeps the tensioner spring under tension.
Remove the belt from the tensioner belt and
motor axis.
Loosen the screws that hold the front and rear
motor fastening rods, lift them up by rotating
them and remove them by pulling them off the
rear hook.
Slightly rotate the whole motor unit.
Lift it up and remove.
6.11 Rotating compressor running capacitor
Remove the worktop.
Remove the right side panel.
Remove the drum rotating motor.
Disconnect the 2 connectors.
Loosen the screws that hold the capacitor in
its slot and remove it by pulling it upwards.
Technical Support - A.D.L.
39/66
599 74 32-54 Rev.01