Sealey VS020TC Manual

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to Wear eye
instructions protection
1. SAFETY
IMPORTANT Operating guidelines are provided with every brake bleeder. However, for definitive information relating to the correct
method of bleeding a particular vehicle's system, always refer to the vehicle manufacturer's instructions.
Familiarise yourself with the applications and limitations, as well as any potential hazards, of the kit.
9
Keep this product in good working order and condition. (Take immediate action to repair or replace damaged parts).
9
Use approved parts only (unapproved parts may be dangerous and will invalidate the warranty).
9
Keep children and unauthorised persons away from the work area.
9
Keep work area clean and tidy and free from unrelated materials.
9
Ensure the work area has adequate lighting.
9
DO NOT use the kit to perform a task for which it is not designed.
8
DO NOT allow untrained persons to use the kit.
8
DO NOT use whilst under the influence of drugs, alcohol or intoxicating medication.
8
After use, clean equipment and store in a cool, dry, childproof area.
9
Dispose of waste liquids in accordance with local authority regulations.
9
Always read and comply with the warnings on the brake fluid container.
9
Wear eye protection and keep skin contact to a minimum. If brake fluid enters eyes, rinse with plenty of water and seek medical
9
advice. If swallowed seek medical advice immediately.
WARNING! Brake fluid is flammable - keep away from sources of ignition, including hot surfaces e.g. exhaust manifold.
‰
WARNING! Brake fluid will damage paintwork. Any spillage should be flushed with water immediately.
‰
After use, clean equipment and store in a cool, dry, childproof area.
9
2. INTRODUCTION
Simple, 1-person operation using standard workshop air supply (90-120psi). Quick, clean and efficient. Does not require specialised brake
reservoir caps. Supplied with two bleed lines for twin caliper systems. Draws fluid from the bleed nipple enabling either bleeding or full
replacement of fluid in system.
3. SPECIFICATION
MODEL NO: .......................................................... VS020TC
Air Consumption: .................................................... 180L/min
Inlet Size: ..................................................................1/4"BSP
Maximum Air Supply: .................................................. 120psi
Tank Capacity: ................................................................... 1L
© Jack Sealey Limited
1L PNEUMATIC VACUUM SINGLE & TWIN
BRAKE CALIPER/CLUTCH BLEEDER
MODEL NO:
Wear protective
gloves
fig.1
Original Language Version
VS020TC
fig.2
VS020TC Issue 1 18/03/2021