Sealey VS0563 Instructions

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to
Instruction
Manual
1. SAFETY
WARNING! Ensure Health and Safety, local authority and general workshop practice regulations are adhered to when using
‰
tools and equipment.
DO NOT use gauge if damaged.
8
Maintain gauge in good and clean condition for best performance.
9
Keep the work area clean, uncluttered and ensure there is adequate lighting.
9
Keep children and unauthorised persons away from the work area.
9
DO NOT use the gauge for any purpose other than for which it is designed.
8
DO NOT get gauge wet or use in damp or wet locations, or areas where there is condensation. Keep gauge clean and dry using a dry
8
cotton cloth only.
DO NOT dip or submerge the gauge in any type of liquid.
8
DO NOT expose gauge to bright sunlight or dust.
8
DO NOT disassemble gauge. The gauge must be checked by qualified service personnel only.
8
DO NOT apply any voltage to the gauge i.e. with an electric marker pen.
8
Take care not to damage or scratch the scale surface.
9
The gauge is a precision instrument, treat with care, avoid using force and do not subject to knocks or shocks.
9
Use gauge in reasonably constant temperature conditions of approximately 20°C.
9
When not in use, turn off and store gauge in a safe, dry, childproof location.
9
2. INTRODUCTION
Calibrated and DVSA approved for use when testing all classes of vehicle. Hardened and tempered stainless steel gauge. Metric and Imperial
calibration with conversion between the two. Zero reset control allows for comparative measurement. Includes flat surface plate for accurate
zeroing of gauge prior to use. Supplied in storage case.
3. SPECIFICATION
Model No: ................................................................. VS0563
Range ........................................................... 0-10mm(0-0.4")
Resolution: ..................................................0.01mm(0.0005")
Accuracy: ..................................................±0.01mm(0.0005")
Battery: .................................................... CR2032 (supplied)
4. OPERATION
© Jack Sealey Limited
TYRE DEPTH GAUGE - DVSA APPROVED
VS0563
MODEL NO:
Original Language Version
Figure 1
Item Description
1 Depth measuring probe
2 LCD Display
3 mm/inch Button
4 Locking screw
5 Base
6 Power "ON/OFF" button
7 Zero set button
8 Battery cover
9 Beam
10 Zero set bar
11 Battery
VS0563 | Issue:7 (H) 26/02/20