Toro Titan MR4800 Operator's Manual page 55

Jump-Starting the Machine (continued)
4. Connect the other end of the positive (+) jumper cable to the positive terminal of the
battery in the other machine.
5. Connect an end of the negative (-) jumper cable to the negative post of the battery in the
other machine.
6. Connect the other end of the negative (-) jumper cable to a ground point, such as an
unpainted bolt or chassis member.
7. Start the engine in the other machine. Let it run a few minutes, then start your engine.
8. Remove the cables in the reverse order of connection.
9. Install the cover to the jump post.
3464-659A
g012785
Page 5–18
Positive (+) cable on discharged
battery
Positive (+) cable on booster
battery
Negative (–) cable on the booster
battery
Negative (–) cable on the engine
block
Booster battery
Discharged battery
Engine block
Maintenance: Electrical System Maintenance