Configuring Ifr 2968 Setup - Motorola MXP600 Manual

MN006362A01-AL
Chapter 4 : Test Setup and Testing
Minimum Mode Service: May Be Used
Migration: Supported
System Wide Services: Normal Mode
TETRA Voice Service: Supported
Circuit Mode Data Service: Supported
(Reserved): Available
TETRA Packet Data Service: Available
Air Interface Encryption: Not Available
Advanced Link: Not Supported
14 Press CONFIG. Select Neighbor Cell Info.
15 Verify that the following NEIGHBOUR CELL INFO values are displayed:
NOTE: The displayed values are factory defaults and should not be changed.
BROADCAST: Not Supported
BROADCAST INTERVAL: 5 s
NEIGHBOUR CELL CHANNEL: 3500
NEIGHBOUR CELL LOCATION AREA: 0017
NEIGHBOUR CELL IDENTIFIER: 01
SLOW RE-SELECT THRESHOLD ABOVE FAST: 10 dB
FAST RE-SELECT THRESHOLD: 10 dB
SLOW RE-SELECT HYSTERESIS: 10 dB
FAST RE-SELECT HYSTERESIS: 10 dB
16 Press CONFIG. Select Call Timers & Trunking.
17 Select Transmission for Trunking Type.
18 Select Continuous for Test Set Transmit Mode.
4.4

Configuring IFR 2968 Setup

Procedure:
1 Turn on the IFR.
2 Press Systems Mode Key and wait until the digital system is initialized.
3 Press Tetra Mobile→Setup. Enter the System Parameters Screen.
4 Press Channel Plan.
5 Press Tetra 380+0MS.
The Control Channel automatically changes to 3600, and Traffic Channel automatically changes
to 3700.
6 Press Traffic Channel→Traffic Channel. Check that the marker goes to Timeslot.
7 To change to Timeslot 3, press 3→Traffic Channel.
8 Press Country Code. Enter 234 and press Country Code.
9 Press Network Code. Enter 2392 and press Network Code.
10 Press Base Color. Enter 1 and press Base Color.
11 Press More.
12 Press Location Area. Enter 22 and press Location Area.
13 Press More.
14 Press Min Receiver Level. Enter -110 dBm and press Min Receiver Level.
38