MN006362A01-AL
Chapter 7 : Radio Disassembly and Reassembly
7.5.2
Installing the Keypad and Mylar Assembly
Prerequisites: Recommended tools:
•
T-5 Screw Bit
•
Torx Driver
•
Plastic tweezers
Procedure:
1 Carefully place the keypad mylar and dome on top of the keypad PCB. Ensure that the keypad
mylar and dome does not cover the two speaker holes.
2 Press the mylar perimeter adhesive and around the mic port area to activate the Keypad Mylar
adhesive. This is done for water and dust sealing and acoustics sealing purposes.
124