Advertisement
Available languages
Available languages
. BRIGHTness control knob
Turn counterclockwise to darken the
picture and clockwise to illumine it.
» CONTRAST control knob
'Turn counterclockwise
to soften con-
trast and clockwise to sharpen.
- COLOUR control knob
Turn clockwise to deepen the colour
tone and vice versa.
. TINT control knob
Turn
counterclockwise
to emphasize
reds and clockwise to emphasize greens.
Normally
set this knob
to its center
click-stop position.
. EARPHONE jack
Plug in the provided earphone; audio
monitoring is possible.
. BATT ALARM indicator
This lamp lights green when the AC
power
cord
is plugged
in and
the
MAINS
POWER
switch is set to ON.
If this lamp lights red during battery
operation, it indicates that the battery
pack
installed
in the unit is nearing
the end of its power.
Immediately
recharge the battery
pack or replace
it with a fresh one.
. INPUT SELECT "VTR" switch
Push this switch to monitor audio and
video signals from a unit connected to
the VTR input connectors
® or @
and @ on the rear panel.
. INPUT SELECT "LINE" switch
Push this switch to monitor audio and
video signals from a unit connected to
the LINE input connectors @ and ®
on the rear panel.
. OFF/VOLUME control knob
Turn this switch clockwise till it clicks
for powering the TM-22EG/EK.
By
turning the knob further you can ad-
just the volume of the audio. Turn the
knob
fully counterclockwise
until it
.clicks to turn the power off. Make ita
rule to put this switch
in the OFF
position after operating the unit and
before recharging the installed battery
pack,
10.
11.
12.
13.
14.
15.
16.
17.
18.
19
CHARGE/MONITOR
switch
Set this switch to MONITOR
for
monitoring
the
picture.
Set
to
CHARGE
for charging
the
installed
exclusive
NB-P1.
Ni-Cd
battery pack.
Battery compartment
Install
the
exclusive
NB-P1
battery
pack here.
MAINS POWER switch
Switching
ON
applies
mains
power
to
the
set.
To
switch
off the
set
completely,
set the power
switch
to
OFF.
AC IN © socket
Using
the provided
AC power
cord,
connect the AC
IN terminal of the
monitor
to an AC
outlet. When
this
terminal
is being
used, the -installed
battery cannot be employed.
Make it
a rule to unplug the power cord from
this
terminal
when
employing
the
exclusive battery pack.
VOLTAGE SELECTOR
To
reset
the
operating
voltage,
see
"POWER SYSTEM" page 1.
DC IN 12 V-—/CHARGE
DIN (7-pin)
socket
Recharging the installed battery pack .
is also possible by connecting the DC
output plug of the AA-P22EG/EK/S
AC
Power Adapter or the TU-22EG/
EK/S tuner adapter to this terminal.
H. HOLD control
Turn
counterclockwise when the pic-
ture is slanting to the right and clock-
wise when slating to the left.
V. HOLD control
Turn in either direction to stop verti-
cal rolling of the picture.
HEIGHT control
Turn in either direction to adjust the
picture if it's too narrow or elongated,
using a screwdriver.
VTR (8-pin) connector
Connect
the monitor
to the video/
audio
monitor terminal of a VTR
or
other video sources.
Advertisement
