Control Panel; Oven Door; Service - Kenmore 911.95402000 Use & Care Manual

BEFORE CALLING FORSERVICE
PROBLEM POSSIBLE CAUSE
Surface units will Improper cookware
not maintain a rolling being used
boil or cooking is not
fast enough,
=
Oven temperature Oven control calibration
seems inaccurate.
POSSIBLE SOLUTION
Use pans which are flat
and match the diameter of
the surface unit selected
r,,
See the temperature
adjustment instructions
following this section
Oven will not Clean cycle is not Oven temperature must
unlock, finished drop below the lock
temperature before the
door will unlock,
: T
Oven light does a, Light switch in off a. Check oven light switch
not work. position on the control panel
b, Oven light bulb loose b. Check the oven
or burned out, light bulb
Oven smokes, a. Dirty oven, a, Check for heavy
spiltover,
b. Improper use of
aluminum foil
b. Use of foil not
recommended
c. Broiler pan containing c. Clean pan and grid
grease left in the after each use,
Oven emits odor. a. Oven insufation may a, Put oven through
emit odor during the self-clean cycle to
first few usages speed up process of
odor "wearing out,"
b. Failure to wipe out b. Wipe excess soil off
excess soil before using oven,
Oven door
accidentally locked
while baking.
Do not force the lock
handle Temperatures
above the locking
temperature wil! prevent
the lock handle from
sliding to the unlock
position
Turn the control knob to
the off position Allow
the oven to cool until the
temperature inside
drops below the lock
temperature and the
handle slides easily
Cleaning results
were poor.
a, Oven was heavily
soiled
b. Clean cycle
interrupted
a. Heavy spillovers
should be cleaned
before the cycle is set,
b, Allow the oven to clean
its full cycle
33