Kenmore 911.95402000 Use & Care Manual page 29

CARE ANDCLEANING
RemovableParts (cont.)
CLEANING MATERIALS
• Dishwashing detergent
• Warm water
• Scouring pad or soap-filled
steel-wool pad
Bump in I__
Rack
Guide
4_
TO REMOVE
1. Pull the racks out to the stop
position.
2. Pull up the front of the rack and
slide under the bump of the rack
guide
TO CLEAN
Clean with warm water and detergent.
For hard-to-remove stains, gently
scrub with a scouring pad or a
soap-filled steel-wool pad Rinse well.
TO REPLACE
1. Place the raised back of the rack
onto the rack guides.
2, Lift the front of the rack unti! the
raised back slides under the bump
of the rack guides
3. Slide the rack all the way back
TO
1.
=
=
4.
5.
TO
1.
1
REMOVE
Fully open the
door.
Push the hinge
locks down
toward the
door frame, to
the unlocked Slot
position,
This may
require a
flat-blade
screwdriver
Hinge Lock
(Unlocked
Position)
Hinge Arm
Firmly grasp both
sides of the door
at the top.
Close door to
the door
removal position.
Lift door up until
the hinge arm is
clear of the slot
Removal Position
REPLACE
Firmly grasp both Bottom Hinge
sides of the door
Edge
of Arm
Slot
at the top.
With the door at
the same angle :
as the removal
position, seat
the indentation
of the hinge arm
into the bottom
edge of the hinge Indentation
slot
continued on next page
29