Yamaha A3000 Upgrade Manual page 40

Changes in UTILITY MODE
UTILITY - MIDI - MIDI
Chapter 2 Upgrade Reference
40
Smp
This is a new page. You access this page by selecting the UTILITY | MIDI function and
then moving to the last page.
You use this page to set up the "MIDI to sample" feature. These settings are effective
only if MIDI-to-sample operation is enabled within the PROGRAM/SAMPLE SELEC-
TION page.
Recall that MIDI-to-sample feature allows you to use MIDI note-on input to switch the
sample being edited.
• Knob 2 or 3 (LayerSelection) selects whether sequential cycling (as set by the upper
or lower setting at the PROGRAM/SAMPLE SELECTION page) is used on all pages
that support MIDI-to-sample operation. You can set the value as shown below. For
information about how layering works, refer to the explanation of the PROGRAM/
SAMPLE SELECTION page, above (
atAllPages
Layered cycling is supported at all pages. Repeated input of a
given note will cause the A3000 to cycle through the samples
(banks) assigned to this note.
atSelectionPage
Layered cycling is used only when you are working at the PRO-
GRAM/SAMPLE SELECTION page. When working at other
pages, the A3000 will not cycle the sample selection in response
to repeated input of the same note.
• Knob 5 (NameView) selects whether the screen displays the sample (bank) name
each time a new sample (bank) is selected by MIDI input. Set to enable to show the
name, or to disable to suppress the display. If you select enable, the name will re-
main on screen for about 1 second following selection by MIDI input.
[MIDI-to-Sample]
16).