Yamaha 01X Software Installation Manual page 20

Setting of mLAN AUTO W.CLK(01X)
19
When the mLAN Driver is installed, the mLAN Auto Connector starts.
To ensure that settings of the mLAN Auto Connector are properly
received, set the mLAN AUTO W.CLK (wordclock) parameter to
ENABLE, as described in the following instructions. These settings
can also be made after the mLAN Auto Connector has run.
Setting on the 01X
19-1
Enter the UTILITY mode by pressing the [UTILITY] button on
the 01X.
19-2
Call up the mLAN AUTO W.CLK display by pressing W.CLK
(channel knob 3).
UTILITY mLAN AUTO W.CLK
ENABLE/DISABLE
19-3
Press ENABLE (channel knob 1).
19-4
The "ENABLE SURE?" prompt is shown. Change the set-
ting by pressing channel knob 8.
• If this parameter is already set to ENABLE, the prompt will not appear,
so proceed to the next step.
• The 01X Utility settings are lost when the power is turned off, unless System
Backup is performed. (Refer to the 01X Owner's Manual.) In order to ensure the
settings here are effective the next time you turn the 01X on, perform System
Backup by holding [SHIFT] and pressing [UTILITY].
20
TOOLS for 01X/Plug-in Effect Installation Guide
Settings in the mLAN Auto Connector
20
[INT : 48 kHz] 1/2
Proceed to the next step.
21
Change the mLAN Auto Connector settings as necessary for your par-
ticular mLAN usage.
Sample Rate .......... Determines the sampling frequency (frequency of
the wordclock)
From 01X to Mac ... Determines the number of mLAN audio transmis-
sion channels from the 01X to the computer.
From Mac to 01X ... Determines the number of mLAN audio transmis-
sion channels from the computer to the 01X. The
latter two channels are connected to the monitor
input.
• Connecting the 01X by using the mLAN Auto Connector may produce noise in
some of the devices. For this reason, make sure to turn down the level of your
amp/speaker system or the MONITOR/PHONES knob/Stereo fader during the
"Connect" operation.
• If you change the Sample Rate to 96 kHz/88.2 kHz when LAYER of the 01X is
set to 17 – 24 (mLAN), LAYER 1 – 8 will be called up and channel 1 will automat-
ically be selected.
Setting the Wordclock Transition Speed
Clicking [Setup] from the mLAN Auto Connector display opens the
serup display
When the wordclock of the 01X is set to slave to an external mLAN
and the incoming wordclock changes, this determines whether the
wordclock will adjust quickly or slowly to match the master word-
clock.
Slow .... The wordclock changes slowly. (This is the usual setting
for most applications.)
Fast ..... The wordclock changes quickly. (This may result in
increased jitter noise.)
Click [Connect]. If the connections are correct, the mLAN Auto Con-
nector completes operation and the mLAN data communication starts,
with the 01X as slave.
• If connection fails, restart mLAN Auto Connector (located in the "mLANTools"
folder in the installation destination), then click [Connect] again.
• When starting the mLAN Auto Connector for the first time, the following files are
included in the Trash. These files can be deleted.
• AutoConnector01X alias
• AutoConnector01X launcher
Proceed to the next step.