Table of Contents
Advertisement
PROGRAMMED EDITING USING THE REMOTE CONTROL
segments of the recording to transfer to a new tape.
This can be only operated with a VCR having a LANC
You can select up to 8 segments of your recorded tape,
Example: To select segments A, B and C froma
recorded tape and copy them in the order A,
gas Note: Connect the LANC cable ®© (¢ 2.5, stereo type)
only after the programmed segments numbers are
displayed on the TV. Connecting it before may cause
incorrect operation.
Connect all the units as illustrated below.
Turn all units on. (Set the camcorder POWER switch to
"PLAYER" )
Playback the tape in the camcorder. When the tape
has reached the beginning of the desired segment,
point A1, press the MEMO button.
will start flashing in the viewfinder and the counter
reading, for the recording start position, is
memorized.
(2 Pre
Press the MEMO button again at the end of the
sired segment, point A2.
ama,
=
A
ate.
tats
a aa
a ine
tee
ae
tae!
S
Ead
hoh
will light (stop flashing) and the counter reading,
for the recording end position, is memorized.
PP PPIE,
3 Repeat steps 1 and 2 for segments C and B in that
order.
:
When the 3 segments have been selected, , Gand
f
4
will be displayed in the viewfinder.
:
4 \ When finished setting the programmed editing, press |
A
the STOP button to stop the tape in the camcorder.
t
Notes:
@ if you need to fast-forward the tape or use the scene
search function to locate the beginning or the end of
a segment, make sure to go back to normal
playback before pressing the MEMO button.
@ The segments should be at least 5 seconds long for
the programmed editing to function correctly.
@ While setting a programmed editing, the counter
cannot be reset.
@ The programmed editing function uses the counter
readings to locate the start and end of the segments.
In some cases, the start and end positions may not
match the exact programmed Positions.
MEMO
ye
h e r s
Meet
he
"MEMO
MEMO
STOP
LAA
F
STOP
16
Advertisement
Table of Contents
