Huawei PDU8000 Quick Installation Manual page 7

NOTE
When cabinets need to be combined, just partially tighten the bolts.
(Optional) Combining Cabinets
NOTE
1. A connecting plate is initially secured by one screw. Remove the screw from the column of the
adjacent cabinet and use the screw to secure the connecting plate.
2. Ensure that both the vertical deviation and the distances between cabinets are within 3 mm
after the cabinets are combined.
1. Level the PDC, as shown by
(1) in the figure.
2. Remove the PDC
connecting kits from the
rack, as shown by (2) in the
figure.
3. Secure the connecting kits
in the connection positions
on the front door using
screws, as shown by (3) in
the figure.
4. Use the same method to
secure the connecting kits
to the connection positions
on the rear door.
5. (Optional) Repeat the
preceding steps to combine
all other PDCs.
6. Use a socket wrench to
secure the PDC.
NOTE
1. In certain scenarios, the UPS modules are installed inside the integrated PDC. For details about the installation
method, see documents delivered with the UPS.
2. Before installing UPS modules inside the cabinet, you must install the cabinet and verify that the cabinet
installation meets the requirements. In addition, you need to obtain the Installation Port Diagram and Schematic
Diagram, and be clear about the number, direction, and quantity of UPS modules to be installed.
3. The appearances of UPS modules differ by model but can be installed in similar ways. The actual product
prevails.
6
(1) Leveling foot
(2) Fixing bolt
(3) Level