5
Data Output
The measurement data are output via CASE™ /
CardioSoft.
Warning
Risk to persons —
While connected to the patient, TONOPORT V
must be disconnected from other equipment
(CASE™, PC).
If the USB port is used (CardioSoft only), it is
necessary to install the appropriate driver first (see
"Software Installation" on page 24).
CASE™ must always be connected to the serial
port.
Put the PC-based system into operation (see CASE™
or CardioSoft Operator Manual).
Turn off TONOPORT V.
Connect TONOPORT V to the PC system:
– via cable 2001589-040, if the USB port of
TONOPORT V is used (a Fig. 5-1)
– via cable 2001589-011, if the serial port of
TONOPORT V is used (b Fig. 5-1)
Turn on TONOPORT V and wait for the time to be
displayed on TONOPORT V.
2001589-085 Revision G
Note
Data Output
For more information about data output, please refer to
the Operator Manual of CASE™ or CardioSoft.
When you have finished downloading data to CASE™ /
CardioSoft and do not intend to continue working with
this system, disconnect TONOPORT V and turn it off.
Fig. 5-1 Connections for PC cable
a
USB port
b
RS232 port
TONOPORT V
a
b
22