Table of Contents
Advertisement
The main harness assembly supplies AC and
DC voltage to all components on the washer. If
a wire or connector should fail, it will need to be
repaired or replaced. If replacing the complete
harness assembly, two technicians will be needed
to complete this repair. The main harness is
secured to the side of the tub using five 1/4-in.
hex-head screws that go through specifically
placed wire ties with eyelets.
Main Harness Removal
1. Remove backsplash assembly (see
Backsplash Removal, under Control Panel
Housing / Backsplash in the Cabinet and
Structure section of this service guide).
2. Remove top cover assembly (see Top Cover
Removal under Top Cover in the Capacitor
(For 600/605 Models Only) section of the
service guide).
3. Remove suspension assembly (see
Suspension Assembly Removal under
Suspension Assembly in the Capacitor (For
600/605 Models Only) section of the service
guide).
4. Lift complete basket assembly by
disconnecting the suspension assembly (see
Suspension Assembly in the Capacitor (For
600/605 Models Only) section of the service
guide).
5. Remove the five hex-head screws (four down
the side of the tub and one on the bottom)
that secure the harness to the tub assembly.
Hex-head
Screws
Main Harness Assembly
– 54 –
6. Remove the harness connectors from the
connector brackets on the bottom of the tub.
7. Disengage the wire ties securing the harness
to the platform assembly and set the harness
aside. New wire ties are already positioned on
the new harness.
Advertisement
Table of Contents
