Bleach Funnel; Bulk Tank (For 900/905 Models Only) - Haier GE PTW600BPR DG Series Technical Service Manual

Bleach Funnel

The bleach funnel directs the liquid bleach to the
top cover, dispensing it between the outer tub
and the basket. There is no water valve to rinse
the funnel after use.
Bleach Funnel Removal
1. To remove the bleach funnel, reach between
the top cover and tub cover and push up on
the bottom of the funnel.
2. Push the undercut ribs tilt the funnel up to
release locating tabs and remove.
Bleach Funnel
Bleach Funnel
To install the funnel onto the top cover, the
locating tab needs to slide into the opening first.
Then push down on the funnel to seat into
position (for 900/905 models only).

Bulk Tank (For 900/905 Models Only)

The bulk tank is used to store 50 Oz., of
detergent, which will dispense automatically
based on the load to the basket with the help of
the dosing pump. It is located at the bottom of
the top cover.
Bulk Tank Removal
1. Remove backsplash assembly and main
board (see the Cabinet and Structure
section of this guide). Remove the top cover
assembly (see the Capacitor (For 600/605
Models Only) section of this service guide).
2. Remove the dosing pump (see Dosing Pump
Removal under Dosing Pump (For 900/905
Models Only) in this section of the service
guide). Remove the bulk tank level sensor
(see Bulk Tank Level Sensor Removal
under Bulk Tank Level Sensor in this section
of the service guide).
3. Remove two hex-head screws, then reach
under top cover and push the bulk tank to
disengage the snaps from top cover and then
remove it.
Screws
– 37 –
Screws
Bulk Tank