Lubricating The Treadmill; Inspection Steps - UREVO STROL 3 User Manual

1. Run the treadmill without load and adjust the speed to 1.0 - 1.5 Km/h;
2. Observe the distance from the Tread-belt to the left and right sidebars:
If it deviates to the left, use an Allen key to turn the left screw clockwise;
•
If it deviates to the right, use an Allen key to turn the right screw clockwise;
•
If the Tread-belt is still not in the middle, repeat the above action until it is
•
adjusted to the middle;
Do not over-tighten the rotary drum as this will cause permanent damage to the
bearing.

LUBRICATING THE TREADMILL:

When the treadmill leaves the factory, Lubricant has been added, but necessary
inspection is more helpful to keep the treadmill in the best condition for use.

Inspection steps

1. Pull up the side Tread-belt and reach out to touch the surface of the running deck
as far as possible;
2. If you feel there is Lubricating oil, you don't need to add Lubricant for the time
being;
3. If you touch the surface and it feels very dry, you need to add 10ml Lubricating oil.
20
Tighten
Tighten