Haier Horno I-Direct x 2 Series User Instructions page 6

order to avoid overheating.
• The oven can be located high in a column or under a worktop.
Before fixing, you must ensure good ventilation in the oven space
to allow proper circulation of the fresh air required for cooling and
protecting the internal parts. Make the openings specified on last
page according to the type of fitting.
• Always fix the oven to the furniture with screw provided with the
appliance
ELECTRICAL WARNINGS
• If the oven is provided by the manufacturer without plug:
THE APPLIANCE MUST NOT BE CONNECTED TO THE POWER
SOURCE USING PLUG OR SOCKETS, BUT MUST BE DIRECTLY
CONNECTED TO THE SUPPLY MAINS. The connection to the
power source must be carried out by a suitably qualified professional.
In order to have an installation compliant to the current safety
legislation the oven must be connected only placing an omnipolar
breaker, with contact separation compliant to the requirements
for overvoltage category III, between the appliance and the power
source. The omnipolar breaker must bear the maximum connected
load and must be in line with current legislation. The yellow-green
earth cable should not be interrupted by the breaker. The omnipolar
breaker used for the connection must be easily accessible when the
appliance is installed. The connection to the power source must be
carried out by a suitably qualified professional considering the polarity
of the oven and of the power source. The disconnection must be
achieved incorporating a switch in the fixed wiring in accordance with
the wiring rules
• If the oven is provided by the manufacturer with plug:
The socket must be suitable for the load indicated on the tag and
must have ground contact connected and in operation. The earth
conductor is yellow-green in colour. This operation should be carried
out by a suitably qualified professional. ln case of incompatibility
between the socket and the appliance plug, ask a qualified electrician
to substitute the socket with another suitable type. The plug and the
socket must be conformed to the current norms of the installation
country.
EN 6