Advertisement
7
Greasing the Hub Assembly
No Parts Required
Procedure
Grease the hub assembly; refer to
Assembly (page
6).
8
Installing the Rear Wheel
No Parts Required
Procedure
1.
Use the previously removed lugnuts to secure
the wheel to the hub
1. Lugnut
2.
Torque the lugnuts (in a crossing pattern as
shown in
Figure
8) to 108 to 122 N∙m (80 to 90
ft-lb).
Greasing the Hub
(Figure
7).
Figure 7
Figure 8
9
Installing the Fuse
Parts needed for this procedure:
1
Fuse
Procedure
Install the fuse to the designated 3-wheel-drive
slot on the reel-drive-circuit fuse block; refer to
the electrical system maintenance section in your
machine Operator's Manual.
10
Engaging 3-Wheel-Drive
Mode
No Parts Required
Procedure
The 3-wheel-drive mode should automatically
enable when you install the gearbox-wire-harness
connections to the machine wire harness.
To ensure that the 3-wheel-drive mode is activated,
navigate to the 3
of your InfoCenter. The item selected/active icon
g300939
indicates that 3-wheel-drive model is activated.
11
Completing the Installation
No Parts Required
Procedure
1.
Lower the machine to the ground.
g274650
2.
Connect the main-power connectors; refer to
your machine Operator's Manual.
5
K
option in the S
WD
IT
ETTINGS
menu
Advertisement
