Advertisement
Front Panel
@ POWER switch and indicator
Switches ON/OFF the power supply. Set the switch to ON
to supply the power to this unit and the connected camera,
and an LED will light.
@SC-PHASE controls
COARSE: Adjusts the subcarrier phase of the camera out-
put signal in three steps 0° — 120° — 240°, with
respect to the subcarrier phase of the external
reference signal (VBS or B.B.).
Adjusts the subcarrier phase of the camera out-
put signal within the range of +60° with respect
to the subcarrier phase of the external reference
signal (VBS or B.B.).
@H. PHASE contro!
Adjusts
the horizontal
sync signal phase of the camera
output signal with respect to the horizontal sync signal of
the external reference signai (VBS or B.B.).
QOCABLE
COMPENSATION controls
These controls allow compensation
of the attenuation
of
the video signal due to the length of the camera cable.
LENGTH:
Set this switch according to the length of the
camera cable used.
FINE:
FINE:
Fine
adjustment
for
compensation
of
the
chroma (color) component of the video signal.
GAIN:
Fine
adjustment
for
compensation
of
the
lurninance component of the video signal.
@ IRIS control mode switch and adjustment control
Controls the iris of the standard
lens of the camera
con-
nected to this unit.
Set this switch to AUTO
to control the iris automatically
and to MANUAL
to contro!
manually
by using the ad-
justment control on the left of the switch.
Note:
When controlling the lens iris with this unit, be sure to set
the iris mode switch of the lens to
"A" mode.
Q@MASTER BLACK control
Varies the black level of the camera connected to this unit.
@ AUTO SET switch, indicator and manual controls
AUTO
SET: Push the switch
upward; the setup (black/
white balance) or white balance of the camera
connected
to this unit will be automatically
adjusted. A single push of the switch (of less
than one second) will engage the auto white
balance
adjustment
mode,
and
holding the
switch pushed for longer than one second will
engage the auto setup adjustment mode.
lights. When
the operation
ends normally, the indicator
will go out; if proper operation did not take place, it will
blink.
e
For errors in white adjustment, it will blink for about 6
seconds at one-second intervals.
RM-P200
REMOTE
CONTROL
UNIT
Notes:
@ if the lamp should blink, set the switch to AUTO SET
again after confirming the connection between this unit
and the camera,
operating conditions
of the camera's
auto-set, etc.
Set to this position to control the gain
of the video signal with the R GAIN and
B GAIN
controls on the right of the
switch.
Q@WHITE BALANCE select switch
unit as follows:
@ Output MODE select switch
Selects the video signal output from this unit.
output the color bars signal.
NEGA:
Outputs the video signal being shot by the camera
as a reversed (negative) signal.
@ SHUTTER switch
1/1000 sec. (1000).
@TALLY lamp
Lights when a rated tally signal is applied to the TALLY
signal input connector on the rear panel.
@® INTERCOM level control and jack
LEVEL: Adjusts the volume of-the intercom.
MANUAL:
PRESET:
Recommended headset: KA-300 (optional)
Advertisement
