Advertisement
TROUBLESHOOTING
FAILURE
OF VIDEO
CIRCUITS
®@ Color reproduction is improper on the monitor TV.
ls the SC PHASE control adjusted correctly?
@ Synchronization is not possible on the monitor.
Is the "MODE"
(camera cable select switch - - page 7) on
the video camera set to "RM''?
Ils the composite video signal {or black burst signal) applied
to the GENLOCK input connector?
ls the VTR signal used as a reference?
Is the external reference signa! applied?
ls the external reference signal
a normal
2:1
interlaced
signal?
® Synchronization is not possibie with the SEG output.
Are connections
to the SEG
input and output terminais
correct?
ts the horizontal (H) phase adjusted?
SPECIFICATIONS
Output signals
Composite video signal : 1 Vp-p, 75 2x2
R/G/B signals
Y/R-Y/B-Y signals
: 0.7 Vp-p, 75 2 x 1 each
(without SYNC)
: Y¥; 1 Vp-p, R-Y; 0.7 Vp-p, B-Y; 0.7 Vp-p,
75 2 each
(burst level)
Y/C 443 signals (E version):
Y; 1 Vp-p, 75 2, C; 0.286 Vp-p, 75 2
Intercom signal
Input signals
Genlock signal
AUX signal
Intercom signal
Tally signal
Others
Power supply
Power consumption
Weight
Ambient temperature
Accessory
Revised on Oct. 1990.
(burst level)
: Two-wire system, —10 dB, 600 2 balanced
: Composite video signal 1 Vp-p,
75 Q {Loop-through output)
Black burst signal 0.43 Vp-p, 75 2
(Loop-through output)
: Composite video signal 1 Vp-p, 75 2
(Loop-through output)
: Two-wire system, —10 dB, 600 2 balanced
: Make-contact or power (5—24 V DC or
6 V AC) supply
: 120 V AC, 60 Hz (U version)
220 V/240 V AC, 50 Hz (E version)
:T1W
65 W (with camera and 4" viewfinder)
: 5 kg (11.1 Ibs)
: —10°C to +45°C (14°F to 113°F)
: Power cord {(QMP1C08-250)
Ip
FAILURE
OF CONTROLS
@ Tally lamp does not light.
Is the power (6 V AC or 5 — 24 V DC) supplied to the tally in-
put
terminal?
Also,
is the power
supply/make-contact
select switch inside this unit in a correct position?
®
{ntercom communication is not possible.
Is the impedance of the headset appropriate?
(Earphone:
200 ~ 600 ohms/1 kHz, Microphone: carbon)
!s the "MODE" switch (page 7) set to "RM''?
@
The auto setup operation indicator does not fight.
1s the color temperature of lighting 3200K?
!s a colored subject being shot?
Are cables, etc., connected correctly?
Dimensions (mm)
160
|O@e
Design and specifications are subject to change without notice.
Advertisement
