Advertisement
1.4.2
Removal of the RM board
3. Remove four screws @
on the FR-1 board.
1. Remove six screws ©) on the rear panel.
Fig. 1-6
2. Remove five screws © on the RM board.
1. Remove the front panel according to the section 1.3,
2. Remove the four knobs @ (refer to Fig. 1-8).
3. Remove three screws
on the FR-2 board.
1.5
ATTACHING THE FR-1/FR-2 BOARD
When attaching the FR-1(or FR-2) board to the front panel,
set the position
of the rotary switch (SHUTTER
on the
FR-1 board, CABLE
LENGTH
on the FR-2 board) accord-
ing to the following procedure.
1. Set the mark
"O" of the rotary switch to the position
"ne
1.4.3.
Removal of the FR-1 board
Fig. 1-10
1-2
Advertisement
